Servo motors vs. DC motors vs. stepper motors: whats the difference?_Overview_Product Wiki_Support_Kpower
Home > Support >Product Wiki >Overview
TECHNICAL SUPPORT

Servo motors vs. DC motors vs. stepper motors: what's the difference?

Published 2026-11-13

DC Motor

ADCmotor is generally divided into two types: brushed DC motorsandbrushless DC motors. It is one of the most basic types of rotary motors. When DC power is applied, a magnetic field is generated through electromagnetic effects, causing the internal rotor to spin at high speed.
Taking the brushed DC motor as an example, the control principle is quite simple: you can change the supply voltage or use PWM (Pulse Width Modulation) to adjust the average voltage. A higher PWM duty cycle generally means a higher motor speed. Reversing the polarity of the power supply changes the direction of rotation. (Note: Brushless DC motors require an electronic speed controller for electronic commutation).
DC motors have a simple structure, low cost, high speed, and relatively simple drive circuits. Simply apply power and the motor starts spinning. However, without an angle sensor, there is no way to know how many revolutions it has completed or which angle it has stopped at. A gearbox is often added to increase the output torque. This combination is commonly known as a geared DC motor.

直流有刷电机

Stepper Motor

Astepper motor contains multiple stator coils. The external driver energizes these coils in a specific sequence, causing the rotor to rotate step by step through a fixed angle, known as the step angle.
The number of input pulses sent by the driver determines the rotation angle. For example, sending 200 pulses can make the motor complete one full revolution.
The pulse frequency determines the motor's rotation speed. The faster the pulses are sent, the faster the motor rotates.
Stepper motors offer high positioning accuracy in open-loop control and do not require feedback from an angle sensor. As long as the motor is not overloaded and does not lose steps, the rotation angle is determined by the number of pulses sent. However, torque decreases as speed increases. If the load is too high or the speed changes too quickly, the motor may lose steps. Once this happens, the control system cannot detect the position error on its own.

步进电机

RCservo

AnRCservo is a highly integrated, closed-loop miniature servo system. It typically contains a small DC motor, a reduction gearbox, a potentiometer (angle sensor), and a control circuit board.
Inside the servo, the angle sensor and control circuit continuously compare the target angle with the actual angle detected by the sensor. The control circuit automatically adjusts the motor's rotation direction until the servo reaches the desired position and holds it there.
The control signal for an RC servo is usually a fixed-period PWM signal.
The duration of the high-level signal (pulse width) directly determines the target angle. For example:
  • A pulse width of 0.5 ms corresponds to 0°.

  • A pulse width of 1.5 ms corresponds to 90°.

  • A pulse width of 2.5 ms corresponds to 180°.

M0090

Comparison & Selection Guide

Feature
Brushed DC Motor
Stepper Motor
RC Servo
Control Mode
Open-loop (Speed)
Open-loop (Position/Speed)
Closed-loop (Position)
Position Accuracy
None (without encoder)
High (within step angle)
Moderate to High
Speed Range
Very High
Low to Medium
Low
Holding Torque
No
Yes (at standstill)
Yes
Typical Use Cases
RC toy cars, cooling fans
3D printers, CNC routers
Robotic arm joints, RC plane rudders


Update Time:2026-11-13

Powering The Future

Contact Kpower's product specialist to recommend suitable motor or gearbox for your product.

Mail to Kpower
Submit Inquiry
WhatsApp Message
+86 0769 8399 3238